On August 15, 2016, Falah Toosi, Salma; Moradi, Sona; Ebrahimi, Marzieh; Hatzikiriakos, Savvas G. published an article.SDS of cas: 3319-31-1 The title of the article was Microfabrication of polymeric surfaces with extreme wettability using hot embossing. And the article contained the following:
Hot embossing was utilized to imprint topog. metallic patterns on the surfaces of thermoplastic polymers in order to create superhydrophobic and superoleophobic polymeric surfaces. The stainless steel (SS) micro/nano structured templates were fabricated using femtosecond laser ablation. The SS laser ablated templates were employed to imprint micron/submicron periodic structures onto the surface of high d. polyethylene (HDPE), polylactic acid (PLA), and medical PVC at temperatures slightly above their m.ps. and pressures in the range of 3-12 MPa. Results have shown that the water contact angle (CA) of imprinted polymers increased to above 160° in the case of PLA and HDPE, while their water contact angle hysteresis (CAH) were significantly below 10°. In the case of medical-PVC, imprinting produced morphologies with high CA and high CAH (petal effect) due to the adhesion forces developed at the interface between the hydrophilic plasticizer of medical-PVC (TOTM) and water droplets. It is also noted that the re-entrant superoleophobic patterns created on HDPE through imprinting closely resemble the patterns found on the surface of filefish skin that is densely angled microfiber arrays. This bioinspired surface is highly capable of repelling both polar (water) and non-polar liquids of low surface tension and meets the superoleophobicity criteria. The experimental process involved the reaction of Tris(2-ethylhexyl) benzene-1,2,4-tricarboxylate(cas: 3319-31-1).SDS of cas: 3319-31-1
The Article related to polyester hdpe wettability embossing, Plastics Manufacture and Processing: Physical Properties and Testing Methods and other aspects.SDS of cas: 3319-31-1
Referemce:
Ester – Wikipedia,
Ester – an overview | ScienceDirect Topics