Extracurricular laboratory: Synthetic route of 14481-08-4

Here is just a brief introduction to this compound(14481-08-4)Quality Control of Bis(2,2,6,6-tetramethyl-3,5-heptanedionato)nickel(II), more information about the compound(Bis(2,2,6,6-tetramethyl-3,5-heptanedionato)nickel(II)) is in the article, you can click the link below.

Quality Control of Bis(2,2,6,6-tetramethyl-3,5-heptanedionato)nickel(II). The protonation of heteroatoms in aromatic heterocycles can be divided into two categories: lone pairs of electrons are in the aromatic ring conjugated system; and lone pairs of electrons do not participate. Compound: Bis(2,2,6,6-tetramethyl-3,5-heptanedionato)nickel(II), is researched, Molecular C22H38NiO4, CAS is 14481-08-4, about Film microstructure-deposition condition relationships in the growth of epitaxial NiO films by metalorganic chemical vapor deposition on oxide and metal substrates. Author is Wang, Anchuan; Belot, Ohn A.; Marks, Tobin J..

High-quality epitaxial or highly textured NiO thin films can be grown at temperatures of 400-750 °C by low-pressure metalorganic chem. vapor deposition (MOCVD) on MgO, SrTiO3, C-cut sapphire, as well as on single crystal and highly textured Ni (200) metal substrates using Ni(dpm)2 (dpm = dipivaloylmethanate) as the volatile precursor and O2 or H2O as the oxidizer/protonolyzer. X-ray diffraction (XRD), SEM/energy dispersive detection (SEM/EDX), and at. force microscopy (AFM) confirm that the O2-derived NiO films are smooth and that the quality of the epitaxy can be improved by decreasing the growth temperature and/or the precursor flow rate. However, low growth temperatures (400-500 °C) lead to rougher surfaces and carbon contamination. The H2O-derived NiO films, which can be obtained only at relatively high temperatures (650-750 °C), exhibit slightly broader w scan full width half-maximum (FWHM) values and rougher surfaces but no carbon contamination. Using H2O as the oxidizer/protonolyzer, smooth and highly textured NiO (111) films can be grown on easily oxidized single crystal and highly textured Ni (200) metal substrates, which is impossible when O2 is the oxidizer. The textural quality of these films depends on both the quality of the metal substrates and the gaseous precursor flow rate.

Here is just a brief introduction to this compound(14481-08-4)Quality Control of Bis(2,2,6,6-tetramethyl-3,5-heptanedionato)nickel(II), more information about the compound(Bis(2,2,6,6-tetramethyl-3,5-heptanedionato)nickel(II)) is in the article, you can click the link below.

Reference:
Ester – Wikipedia,
Ester – an overview | ScienceDirect Topics